Nacht der Ruinen
Deutsch
Apple BooksFebruary 5, 1943
United States War DepartmentDiese Ausgabe ist in einer anderen Sprache. Bücher in deiner Sprache finden ↗
a. This manual is intended to serve temporarily (pending the publication of a more complete revision) to give information and guidance to the personnel of the using arms charged with the operation, maintenance and minor repairs of this materiel.
b. Disassembly, assembly and such repairs as may be handled by the using arm personnel will be undertaken only under the supervision of an officer or the chief mechanic.
c. In all cases where the nature of the repair, modification, or adjustment is beyond the scope or facilities of the unit, the responsible ordnance service should be informed in order that trained personnel with suitable tools and equipment may be provided, or proper instructions issued.
a. The manual is divided into two parts. Part One consists of sections I through IX which contain information chiefly for the guidance of operating personnel. Part Two consists of sections X through XXIII, and contains information chiefly for the guidance of the using arm personnel doing maintenance work.
3. CHARACTERISTICS (figs. 1, 2, 3, 4, and 5).
a. Heavy Tanks M6 and M6A1 are armored, full tracklaying vehicles, each powered by an aviation-type, radial, 9-cylinder, air-cooled gasoline engine.
b. The engine is located in a compartment directly behind the driving compartment. Access to the engine, for replacement of certain accessories and the performance of limited maintenance operations, is provided by a door in the front engine compartment bulkhead, four hatch covers in the engine compartment top plate, and two removable inspection plates in the floor of the engine compartment.
c. The assembled torque converter, transmission and final drive are mounted directly behind the engine. The driving sprockets are thus at Figure 4— Top Rear View— Heavy Tank M6 the rear of the vehicle, differing from the position of the sprockets as used on the medium tanks. A flexible coupling connects the engine to the torque converter, no propeller shaft being used on this vehicle. The hydraulic torque converter is a form of hydraulic transmission which applies the engine horsepower to the final drive. Fluid, such as No. 1 grade Diesel fuel, is the operating medium of the torque converter, there being no mechanical connection between the input and output ends of the torque converter. Since the drive is through fluid, no clutch is used on the vehicle. A pedal, placed in the position usually occupied by a clutch pedal, serves as a transmission brake pedal. In order to shift, the converter turbine and transmission gears must be slowed down or stopped by means of the brake. Two forward speeds and one reverse speed are provided.
d. Tracks used on the Heavy Tanks M6 and M6A1 are double tracks, a track block consisting of 2 shoes held together by connecting pins. Pins are bare between the shoes, to provide space for a center track connector. This differs from the conventional track connector in that it Figure 5 — Top Rear View with Hatch Doors Open— Heavy Tank M6 consists of two parts which clamp around the pins, held together by a bolt and safety type nut. Track shoes are half rubber and half steel, the rubber section being placed on the inside of the track to run next to the bogie wheels and idlers when the track is installed. Tracks may not be reversed, although under certain conditions, and when approved by the officer in charge of maintenance, they may be turned end for end.
e. A main idler is provided to adjust each track. Idlers are designed to slide forward and back in two slots in the idler block, adjustment being provided by drilled jackscrews. An auxiliary, nonadjustable idler is mounted between the main idler and the front bogie assembly.
Republished by Liber Copia LLC for convenient study and reference on any device.