Kill Shot
Deutsch
March 14, 1945
United States War DepartmentDiese Ausgabe ist in einer anderen Sprache. Bücher in deiner Sprache finden ↗
a. Radio Set AN/TRC-10 (fig. 1) is a low-power, c-w (continuous-wave) ground transportable communications set consisting of Receiver-Transmitter RT-46/TRC-10, a rectifier power supply, a vibrator power supply, a hand generator, and a number of associated items (par. 5). The radio set is designed for general field use and is supplied with a 50-foot and a 100-foot wire antenna.
b. The transmitter section of Receiver-Transmitter RT-46/ TRC-10 covers a frequency range of from 2,000 to 12,000 kc (kilocycles) (2.0 to 12.0 me (megacycles) ) which is divided into crystal-controlled channels. The transmitter has a c-w output of 20 watts.
c. The receiver section of Receiver-Transmitter RT-46/TRC-10 is designed for the reception of amplitude-modulated voice and tone signals or c-w signals, and covers the frequency range of 2.0 to 12.0 me in two bands: 2.0 to 5.0 me, and 5.0 to 12.0 me. Provision is made for checking the calibration of the receiver section by using the crystal-controlled oscillator in the transmitter section.
d. The average distance range of the transmitter is 20 miles; however, this range will vary with the operating frequency, time of day, antenna length, and operating conditions.
a. A simplified block diagram of the radio set is given in figure 2 and shows the inter-relation of the various components. Any one of three power supply units may be used with the receivertransmitter; the unit used will depend on the primary power source that is available.
Figure 2. Radio Set AN/TRC-10, simplified block diagram.
b. The transmitter section of the receiver-transmitter develops a continuous r-f (radio-frequency) carrier which is applied to a common antenna through a manual switch on the front panel of the receiver-transmitter. The r-f carrier is keyed by a telegraph key plugged into the KEY jack on the transmitter section front panel.
c. The receiver section is a five-tube superheterodyne receiver designed to receive tone-modulated, voice-modulated, and c-w signals. The receiver uses the common antenna and is so designed that when the antenna is connected to the reeceiver, the transmitter section will not operate. When transmitting, the receiver audio-output stage is converted into an audio oscillator which is keyed along with the transmitter for monitoring purposes. A headset is provided with the radio set; however, sufficient audio power is available to operate a small speaker.
d. The common antenna consists of a 50-foot and a 100-foot length of wire equipped with insulators for fastening to near-by trees, buildings, or similar objects. Either antenna may be used separately, or the two sections may be connected in series to give a total length of 150 feet.
Contents
• Part ONE: Introduction
• Section I: Description of Radio Set AN/TRC-10
• Part TWO: Operating instructions
• Part THREE: Preventive maintenance
• Part FOUR: Auxiliary equipment
• Part FIVE: Repair instructions
• section 86
• section 88
• section 89
Republished by Liber Copia LLC for convenient study and reference on any device.