Threshing Day
Italiano
Apple BooksJune 29, 1945
United States War DepartmentQuesta edizione è in un’altra lingua. Trova libri nella tua lingua ↗
These instructions are published for the information and guidance of the personnel to whom this equipment is assigned. They contain information on the operation and maintenance of the equipment as well as descriptions of major units and their functions in relation to other components of the equipment. They apply only to the Evinrude Engines, Lightfour Models 4375, 4376, and 4377, and Zephyr Models 4359, 4361, 4362, and 4363 (figs. 1 and 2). These instructions are arranged in three parts: Part One, Introduction; Part Two, Operating Instructions; Part Three, Maintenance Instructions. Other publications applicable to the material covered by this manual are listed in the appendix.
Preventive maintenance service on these engines is based on WD AGO Form 55-124 (Marine Craft Operator's Daily Trip Ticket and P.M. Service Record); and on WD AGO Form 55-125 (Preventive Maintenance Service and Technical Inspection Work Sheet for Marine Craft). WD AGO Form 468 (Unsatisfactory Equipment Report) will be used to report unsatisfactory engines.
Section 11. DESCRIPTION AND DATA a. General. The Lightfour and Zephyr models of the Evinrude engine are outboard gasoline engines of the two-cycle, four-cylinder, crankcase-compression type. They have two decks of opposed cylinders firing alternately in pairs. The chief differences between the two models are in brake horsepower, weight, and piston displacement. (See tabulated data, par.
6. Ignition. Both models have waterproof, built-in-flywheel magneto ignition.
c. Lubrication. See paragraph 21.
d. TiLT-UP. Both models tilt automatically when encountering submerged obstructions or when beaching. They have a tilt-up stop to limit upswing.
e. Miscellaneous. Both models have motor rests and provisions for attachment of steering fittings.
OrlginaJ from UWIVERSITY OF CALIFORNIA Gasoun£ Tank A//? ///vr P/P£ Pump hqusinq bear housing Origiriiai from UNIVERSITY OF CALIFORNIA Figure 2, Light four engine.
Origirial from UNIVERSITY OF CALIFORNIA N.O.A. Certified Brake Horsepower 5.4 N.O.A. certified brake horsepower at 4,000 rpm 9.7 N.O.A. certified brake horsepower at 4,000 rpm Average running time at full speed Holds 6% pts. 1 to ll hrs.
Holds IV4. gals. % to 1/4 hrs.
Gears and gear ratio-engine to propeller Propeller as supplied with engine' Number of b] des Estimated speeds in mph on:
Average row boats, service dinghies, etc.
Propeller protection Clutch and skeg Rubber cushioned Drive and skeg Type of pump giving positive cooling Float-feed auto type with silencer and indicator dial Float-feed auto type with silencer and indicator dial Type of carburetor priming device Over-all dimensions, omitting steering handle Standard models Starter models WeiRhts vary according to material substitutions.
= Standard propeller supplied on engine is suitable for use on most boats. If used on extremely light boat with light load, resulting in rpm beyond 4,000, special high speed propeller should be used.
Section III. TOOLS. PARTS. AND ACCESSORIES Listed below are tools, parts, and accessories supplied in a kit with the equipment when the equipment is issued to using organizations. These are illustrated in figures 3(1) and (2). After using tools and equipment, clean and dry them thoroughly before storing.
Feeler, breaker, and spark plug Pins, cotter, propeller nut Hammer, ball peen, % lb. Wrench, open-end, %6 x % in.
Republished by Liber Copia LLC for convenient study and reference on any device.